Three Dimension® products are carefully engineered and in-assembly-line tested to provide a lifetime of trouble-free use. For optimum performance of your new Faucet, a proper water pressure of 1-6 bar is recommended. If you have any questions regarding our products, please contact us.
Simple care instructions
Dry the faucet with a clean soft cotton cloth.
DO NOT:
Use any abrasive cleansers, cloths, or paper towels.
- Use any cleaning agents containing acids or polish.
- Use any abrasives, harsh cleansers or soaps.
---------------------------------------------------------------------------------------
Heavy cleaning procedure (if necessary)
Use any of the following to remove tough surface film and buildup:
- Mild liquid detergents.
- Clear liquid glass cleaners.
- Non-acidic, non-abrasive gentle liquid or fully dissolved powdered cleansers mixed according to manufactures specifications.
- Non-abrasive liquid polishers.
- Once clean, rinse faucet again with clear water to thoroughly remove cleanser and blot dry with a soft cotton cloth.
If you have any doubts or questions concerning care and maintenance of your faucet, please contact your local authorized Sanliv dealer or email us for assistance.
---------------------------------------------------------------------------------------
Cleaning the Aerator.
Should you experience diminished flow after extended use, the aerator may be clogged with limestone deposits and water stains. To clean the aerator follow these steps:
- Using aerator removal tool unscrew aerator from faucet/mixers/tap.
- Remove aerator seal and aerator cartridge from aerator.
- Clean aerator cartridge and spray ring. If lime has formed, dip the aerator into water and vinegar, leaving it to soak until the lime is easily removed by light scrubbing.
- Installation is the reverse of removal.
When screwing in aerator/sprayer housing, the assembly will stop when fully installed. No further hand-tightening will be possible. Do not over tighten by using tools other than the supplied tool to install.
---------------------------------------------------------------------------------------
Removing the Cartridge.
If you ever experienced leakage around the handle area, it may be necessary to replace he cartridge from your faucet. Follow these steps to remove the cartridge:
- Shut off water. Using a wrench, remove set screw from handle. Lift off handle. Remove top dome-shaped cap by pulling upwards.Uing pliers, unscrew the retainer ring. Carefully remove cartridge by pulling straight up on stem with pliers.
- Reassemble by reversing steps.
|
